We make the parts that wear out inside centrifugal, process and slurry pumps: impellers, casings, shafts, wear rings, sleeves and seal components.
That focus decides how the plant is laid out — pattern making and casting on one side, CNC turning and milling on the other, with balancing and inspection between them and the shipping door. A part is not released until its dimensional report and its balance grade are on paper.
Company history, ownership, headcount and founding date are placeholders in this demo pending the client’s real details.
Investment, shell mould and sand casting, CNC machining, heat treatment, balancing and inspection — the whole route under one roof, so nobody has to coordinate three suppliers to get one impeller.
Manufacturing CapabilitiesWe do not sell pumps and we publish no standard product list. Every part leaves against a drawing, a 3D file or a worn sample.
Single aftermarket replacements and repeat production batches run through the same route; only the casting method and the tooling amortisation change.
Spectrometer on every heat, CMM dimensional reports, dynamic balancing to ISO 1940, and NDT where the specification calls for it.
Anything not dimensioned on your input appears on our quotation as a stated assumption, rather than being decided quietly on the shop floor.
Upload a 2D drawing, 3D file, nameplate photo or a picture of the worn part. We review material, tolerances, process route and inspection needs, then come back with a firm quotation.
Request a Quotation